Table of Contents
Advertisement
L
ISTENING TO EXTERNAL AUDIO INPUT
The FTM-10SR enables you to output the audio signal from the external audio equipment
such as an iPod
to the speaker. You may operate on the amateur band while listening to
®
your favorite music.
1. Turn off the FTM-10SR and external audio equipment.
2. Connect the Supplied "SP/LINE-IN" Cable to the "SP/LINE-IN" jack of the Trans-
ceiver Body.
3. Connect the external audio equipment to the LINE-IN Jack (blue) of the "SP/LINE-IN"
cable.
The connection cable depends on the external audio equipment you connect. Please
ask your dealer.
Wrap the LINE-IN jack with electrical tape (not supplied) to protect moisture ingress.
4. Turn on the FTM-10SR by pressing and holding the [ POWER ] key for two seconds.
5. Press the front panel
6. Turn on the external audio equipment.
Press the [ VOL/SEL ] key to adjust the volume (AF level) of the audio output level.
While the RED LED is on, the volume level can be adjusted with the dial knob.
The volume level is displayed on the LCD.
Adjust the audio input level at the external audio equipment side.
You may monitor the amateur band and external audio signal at the same time when
you activate the Club Channel Monitor function.
You may enjoy stereo listening from external audio Input. Use the optional BH-1
Bluetooth
®
speaker, and set the Menu Item "F42 STEREO". See page 87 for detail.
When you have finished listening to the external audio, press front panel
select another band.
Audio output "L"
Audio output "R"
FTM-10SR O
PERATING
/
key to select the "LINE-IN" band.
Headset with the FEP-4 Ear Phone for BH-1 or an aftermarket stereo
GND
M
ANUAL
LINE-IN Jack (Blue)
/
key to
59
Advertisement
Table of Contents
