Chapter 9 - Optimus 5900 Rfid Ebase Device (Model: 5900-Ehb); Overview - Honeywell 5900 RFID User Manual

9
Optimus 5900 RFID eBase Device (Model: 5900-EHB)

Overview

The Ethernet Base (eBase) enables a single O5900 terminal to communicate with a host device over an
USB, serial RS-232, or Ethernet network.
The 5900-EHB charger is designed for use with battery pack models BP08-000640 (standard Li-poly 3.7
V, 5000 mAh) manufactured for Honeywell International Inc. and to be used with Optimus 5900 model
terminals.
Communication
The eBase can communicate via USB, serial RS-232, or Ethernet network. Data transmission for USB is
up to 12 Mbps. Data transmission for serial RS-232 is up to 115 Kbps.
These bases cannot be physically connected to each other–sometimes referred to as "daisy-chaining"–
but can be networked together via serial or USB hubs.
Battery Charging
The base completes a full charge of a fully depleted main battery pack in an average of 7 1/2 hours. It
takes less time if the battery has some charge.
In addition to charging, the base powers the terminal's intelligent battery charging system, which protects
the battery from being damaged by overcharging. The terminal senses when a battery pack is fully
charged and automatically turns off the charger. If the battery voltage drops below the charge threshold,
the charger turns on again to maintain the battery at full capacity. As a result, Optimus 5900 RFID
terminals may be stored in the base indefinitely without damage to the terminals, battery packs, or
peripherals. For prolonged storage, see
second battery while the terminal is positioned in the base. See
Power Supply
The power cable that ships with each terminal also powers the base.
We recommend use of Honeywell peripherals, power cables, and power adapters. Use of any non-Honeywell
peripherals, cables, or power adapters may cause damage not covered by the warranty.
We recommend use of Honeywell Li-Ion battery packs. Use of any non-Honeywell battery may result in
damage not covered by the warranty. DO NOT attempt to charge damp/wet mobile computers or batteries.
All components must be dry before connecting to an external power source.
Storage Guidelines on page 3-13. The base can also charge a
Charging a Spare Battery on page 9-4.
9 - 1