Managing Main Battery Power - Honeywell 5900 RFID User Manual

Changing the Main Battery Pack
Before installing a battery pack, press the Power button to put the terminal in
3-15) so that operations are suspended before removing the main power source. The Optimus 5900 RFID
terminal is shipped with the battery separate from the unit. You will need to remove the battery door, insert
the battery, and replace the battery door. Refer to the instructions included in
section (page 2-1).
Note: The battery door must be installed prior to booting the unit.
Charging
When the battery is installed in the terminal, you may charge the device by either using the USB cable or
by placing the terminal in the
To fully charge the Li-Ion battery before installing it in the terminal insert the battery in the spare battery
charging well in the back of Optimus 5900 RFID eBase.
Charging Time
The 5000mAh battery pack charges to full capacity in an average of 7 hours for a fully depleted battery.
It takes less time if the battery has some charge.

Managing Main Battery Power

Data and files saved on the Optimus 5900 RFID terminal may be stored in RAM memory; therefore,
maintain a continuous power supply to the terminal to help prevent data loss. When you remove a battery
pack, insert another charged battery pack into the Optimus 5900 RFID terminal. If the main battery pack
is low, insert the terminal into a charging peripheral to power the terminal and begin recharging the
battery.
Note: If the main battery is low and the terminal is in Suspend Mode, pressing the
the Optimus 5900 RFID terminal; you must first replace the discharged battery with a fully charged battery or
apply A/C power to the terminal.
3 - 12
Optimus 5900 RFID eBase Device (Model: 5900-EHB)
Suspend Mode (see page
Installing the Main Battery
Main Battery
(see page 9-1).
Power
not
button does wake