Master/Slave Fixture Linking; Mounting; Orientation; Rigging - Chauvet Kinta X User Manual

Master/Slave Fixture Linking

1. Connect the (male) 3 pin connector side of the DMX cable to the output (female) 3 pin connector
of the first fixture.
2. Connect the end of the cable coming from the first fixture which will have a (female) 3 pin
connector to the input connector of the next fixture consisting of a (male) 3 pin connector. Then,
proceed to connect from the output as stated above to the input of the following fixture and so on.
Often, the setup for Master-Slave
and Standalone operation requires
that the first fixture in the chain be
initialized for this purpose via either
settings in the control panel or DIP-
switches. Secondarily, the fixtures
that follow may also require a slave
setting. Please consult the
"Operating Instructions" section in
this manual for complete instructions
for this type of setup and
configuration.

Mounting

O RI ENT AT I O N
This fixture may be mounted in any safe position, provided there is adequate room for ventilation.
RI G G I NG
It is important never to obstruct the fan or vents pathway. Mount the
fixture using, a suitable "C" or "O" type clamp. Adjust the angle of the
fixture by loosening both knobs and tilting the fixture. After finding the
desired position, retighten both knobs.
When selecting installation location, take into consideration lamp
replacement access and routine maintenance.
Safety cables must always be used.
Never mount in places where the fixture will be exposed to rain, high
humidity, extreme temperature changes or restricted ventilation.
Do not mount more than 3 fixtures using the X-bracket.
Note: The X-bracket is compatible with linking DerbyX, Double Derby X, and Kinta™ X.
Kinta™ X User Manual
Slave Slave
X-bracket
8
Master
Hanging Clamp
Note!
Clamp is sold separately.
12/16/2008 2:53 PM