Included In This Package; Install/Remove Antenna - Cobra MR HH450 DUAL Owner's Manual

Included in this Package

Radio Controls
and Indicators
Owner's Manual Introduction
Belt Clip
Antenna
Battery
Battery
Door
Backlit Speaker/ Screw
LCD Microphone
Screen External Cover ON/OFF/
Volume Control
Push to
Talk
Button
Channel
Down Bluetooth
Button Microphone
R ROG VHF
Backlight/ T X Channel
Key Lock A Up Button
Button B U C I
LOMEDHI SAME MEM Rewind-Say-Again ®
Button
Bluetooth MARINE HH500
Button Instant
Channel
Call/Enter 16/9 Button
Button ENT SETUP CALL
TW 16/9
ESC MEM Memory/Escape
Button
MR HH450 DUAL
Tri-Watch
Button SUBMERSIBLE
Power
SCAN Button Level/Weather
Button
Nothing Comes Close to a Cobra ® English VHF Microphone
Speaker
A2 English

Install/Remove Antenna

1. To install the antenna turn the antenna into the radio
clockwise to tighten. Do not overtighten.
2. To remove the antenna turn the antenna counterclockwise.
This radio transmitter IC: 906A-MRHH450 has been
approved by Industry Canada to operate with the supplied
antenna. Other antennas are strictly prohibited for use with
this device.
Cet émetteur radio IC: 906A-MRHH450 a été approuvé par
Industrie Canada pour fonctionner avec l'antenne fournie.
D'autres antennes sont strictement interdits pour une
utilisation avec cet appareil.
Batteries and Charger
The radio is shipped with a sealed lithium-ion (LiON) battery
pack (P/N CM 110-026) that is rechargeable.
WARNING
The charger provided for this radio is only to be used
to charge the battery pack provided. Do not charge
any other type of batteries in the charger as fire,
explosion or battery damage will occur. Avoiding
extreme room temperatures will also help prolong
the life of the battery pack for the radio.
When your rechargeable batteries begin to discharge too
quickly, it is time to install a new battery pack. Your radio
will also operate with five (5) high-quality AA alkaline
batteries, using the included alkaline battery tray.
1. Position the battery pack over the back of the radio.
2. Engage the battery pack into the radio by sliding to the top
until battery pack is fully seated against radio housing.
3. Tighten the screw using the end of the belt clip to secure
the battery pack to the radio. Do not overtighten. Only use
the end of the belt clip to tighten the screw.