Start Here - InSinkErator C1300 Owner's Manual

START HERE

proper installation shoulD take aBout 2-4 hours
1
PREPARATION
A
Required minimum from
⁄
center of hole to wall is 4
3
8
1 " – 1
Note: Hole size requirement is 1 ⁄
4
The wall outlet for your dispenser must have
power supplied to it continuously and must be
fused. It should not be controlled by the same
wall switch that operates your disposer.
b
If you have to drill through
sink or countertop, you may need to
rent or purchase the appropriate tools.
Electric Shock Hazard: Using an ungrounded or improperly connected
appliance can result in serious injury or death from electrical shock.
This appliance must be grounded. This instant hot water dispenser is equipped with a cord that has
a grounding conductor and a grounding pin. The plug must be connected to an appropriate outlet that is
properly installed and grounded in accordance with all local codes and ordinances.
Do not modify the plug provided with the appliance.
4
Identify locations for the dispenser
faucet, tank and filter (if applicable).
Check to make sure there is proper
clearance (see chart at left) for
1 "
⁄
2
dispenser handle to be fully opened.
Check to make sure counter is 3"
thick or less.
Make sure there is a grounded
electrical outlet within 30" of the tank.
Turn off water supply.
If using the sink sprayer hose hole,
remove nut that connects sprayer
hose at bottom of faucet.
Using adjustable wrench, remove nut
connecting sprayer washer flange in
sprayer hole.
Plug hose opening with either a 1/8"
plug or a 1/4" cap (not supplied).
2
INSTALLING THE FAUCET - C1300
A
NOTICE
Property Damage: Do not pinch or break copper
tubing. Do not distort the last 1 inch of tubing.
b
Make sure to use rubber O-ring
to ensure proper seal.
c
1
2
An assistant may be needed
to hold the faucet in place
while securing the dispenser.
d
3
Semi-circular mounting plate should
encircle all descending tubes and
extend beyond sink hole when tight.
C1300
Unpack dispenser components.
On a firm, flat surface, carefully
straighten the copper tubing.
C1300
Ensure that the black O-ring is
properly seated in the base of the
faucet (the groove on the underside
of the faucet base).
C1300
Feed tubes down through the hole
in the sink or countertop until the
base is at rest on the sink or
countertop surface.
C1300
1
From under the sink, place the
1
2
semi-circular mounting plate onto the
threaded stud.
Place hex nut onto the threaded stud.
Ensure faucet is at desired angle.
Insert screwdriver into hole on side of
hex tool (creating a "T"), and use tool
to tighten nut and secure faucet.
3
For Technical Assistance
1-800-845-8345
1
Brass Nut
F
2
3
5