Robertshaw RS4110 Installation Manual page 10

Default EnergyStar™ Settings for RS5000 and RS6000
The RS5110, RS5220, RS6110 and RS6220 are programmable thermostats
and are preprogrammed with a schedule that is recommended by
EnergyStar™. The schedule is designed to lower energy costs year-round.
Morning (6:00 am)
Day (8:00 am)
Evening (6:00 pm)
Night (10:00 pm)
Setting Time and Day for RS5110, RS5220, RS6110
and RS6220
To adjust the time and day settings press the SET TIME button. The hour will
flash. To change the settings:
1. Use the
2. Press the SET TIME button to move through hours, minutes and days
of week.
3. Make changes as needed. They will be saved automatically.
NOTE: THE THERMOSTAT WILL NOT CORRECT FOR
Installation Test Utility
WARNING: The installation test procedures can damage the
heating/cooling equipment if used incorrectly. These procedures should only
be performed by trained HVAC personnel.
The following instructions may be used to test the heating/cooling system for
correct function.
To enter the test mode press and hold
While in test mode, only the
are active.
Short Cycle protection is disabled when using the test utility.
Push the Start/Stop schedule button at any time to exit test mode.
In the test mode:
Press to force the fan on or off. The fan icon will rotate. If the selector
switches are set for NON-HP and GAS, the fan icon will not be displayed.
Pressing
following tables. The display will show appropriate animated icons.
EnergyStar™ Temperature Settings
Winter (Heating)
and buttons to change the flashing number.
DAYLIGHT SAVING TIME.
repeatedly will allow testing of the system modes. See
70°F (21°C)
62°F (17°C)
70°F (21°C)
62°F (17°C)
and
, and Start/Stop Schedule buttons
10
Summer (Cooling)
78°F (25°C)
85°F (29°C)
78°F (25°C)
82°F (28°C)
for ten seconds.