Table of Contents
Advertisement
Disconnect power before attempting any
maintenance or cleaning to reduce the
risk of fire, electrical shock or personal
injury.
Louvre Removal
To remove top louvre pull louvre up and then lift out.
(Fig. 6)
2.
1.
Fig. 6 Remove louvre assembly.
Glass Frame Removal
NOTE: Applicable only to units with glass.
1. Turn off electrical supply to unit.
2. Let fireplace cool if it has been operating.
3. Remove top louvre. (See Louvre Removal).
4. Open lower louvre assembly.
5. Remove two door retention screws along lower sides
edge of door frame.
6. Swing lower portion of door out from the fireplace
and gently lift up to disengage top of door from
fireplace. (Fig. 7)
7. To reinstall glass door, reverse the above procedure.
Retaining
Screws
Window
Frame
Fig. 7 Window frame assembly removal.
10005721
Service Instructions
Louvre
Glass Panel
FP444
Glass /
Frame
Fireplace
Front
Window
Frame
Screws
FP1204
Pyromaster Electric Fireplace HEF33
Glass Information
NOTE: Applicable only to units with glass.
1. Under no circumstances should this product be
operated with missing or broken glass.
2. Do not strike or slam the glass.
3. Do not use abrasive cleaners to clean the glass.
4. This product uses tempered glass. Replacement of
the glass with gasket as supplied by the
manufacturer should be done by a qualified service
person.
Replacing Light Bulbs
This fireplace uses three (3) clear 120 Volt, 60 Watt,
E-12 socket base light bulbs (small-base, chandelier
candle type). These lights are located under the ember
bed of the unit. For convenience, if one of the bulbs
burns out, it may be a good idea to replace all of the
light bulbs.
Do not exceed 60 Watts per bulb. Use of
higher rated bulbs may result in a fire,
causing property damage, personal
injury or loss of life.
1. Turn off power to the unit.
2. Allow fireplace to cool if it has been operating.
3. Remove top louvre. (Refer to "Louvre Removal"
section.)
4. Remove glass door or bay window. (Refer to "Glass
Frame Removal" section or "Bay Window Removal"
section.)
5. Remove the four (4) screws securing the ember bed
in position. Two (2) screws are located on either side
of the ember bed near the back.
6. Examine the bulbs to determine which bulbs need to
be replaced.
7. While holding the socket, unscrew the defective
bulb(s).
8. Install the new light bulb(s) by screwing in while
holding the socket.
9. Reinstall ember bed, log set, glass door or bay
window, and top louvre.
7
Hide quick links:
Advertisement
Table of Contents
