Operating Instructions; Main On/Off Switch; Heater Control; Flame Speed Control - pyromaster HEF33 Homeowner's Installation & Operating Manual

The control compartment is located behind the lower
louvre panel. To access the controls, simply flip down
the lower louvre panel. Refer to Fig. 9, below, to locate
the position of each control, .

1. Main On/Off Switch

The ON/OFF switch supplies power to all functions of
the fireplace. This is an illuminated switch that normally
lights up when in the ON or OFF position.
During any service of this appliance, the
power to the unit must be turned off. It is
not acceptable to use the ON/OFF switch
to meet this requirement.
See Installation Instructions for service
details.
WARNING: Disconnect Power Before
Servicing.
WARNING: Risk of fire, keep electrical
cords, draping, and other furnishings at
least 3 feet (0.9m) from the front of the
heater.
Voir les instructions d'installation pour
des details sur le service.
AVERTISSEMENT: Debrancher la source
d'alimentation avant le service.
AVERTISSEMENT: Risque d'incendie,
veiller a ce que les cordons electriques,
tentures et autres textiles domestiques
soient a au moins 3 pieds (0,9m) de
I'avant de I'appareil de chauffage.
Fig. 9 HEF33 control panel.

4. Re-learn

This model fireplace with integral remote control has a
preprogrammed, matched-pair Receiver/Transmitter
already set with randomly-selected house codes. It is
highly unlikely that the fireplace code will ever need to
be re-learned. If the fireplace needs to re-learn
Receiver/Transmitter house codes, perform the
following steps:
1. Be sure there is power to the fireplace.
2. Be sure there is a good battery in the Transmitter
(hand-held remote).
3. Open the battery compartment of the remote.
4. Press and release the small button located in the
top left corner. This will randomly select a new
house code in the remote Transmitter.
5. Close the remote Transmitter battery compartment.
10005721

Operating Instructions

Control Panel

3
GOLD GOLD
GOLD
Pyromaster Electric Fireplace HEF33
The Heater Control acts to turn the heater on and off as
well as setting the comfort level in the room. Turning
the knob clockwise from the off position will place the
heater into operation. The further the knob is rotated
clockwise, the higher the set point temperature. Turn-
ing the knob counter-clockwise will lower the set point
temperature. Turning it all the way counter-clockwise
will turn the heater function off.

3. Flame Speed Control

Turn the flame speed control knob to increase or decrease
the flame speed as desired.
2 1
RED
6. Press either the ON or OFF button on the remote
Transmitter, and the Learn button on the fireplace
at the same time. The fireplace is now ready to
accept commands from the remote Transmitter.
The ON/OFF button on the fireplace (below the Learn
button) is to turn the fireplace ON and OFF when the
battery in remote Transmitter is weak, or to manually
operate the fireplace without the remote Transmitter.
NOTE: The device complies with Part 15 of the
FCC Rules. Operation is subject to the
following two conditions:
1. This device may not cause harmful
interference, and
2. This device must accept any interference
received, including interference that may
cause undesired operation.

2. Heater Control

5 4

5. ON/OFF

LEARN
ON/OFF
10005509
FP1210
11