Code Squelch - RELM RPV599A Owner's Manual

•
If [A], [B], [C] and [D] keys have been set as inactive in the manual dial mode, these
keys still can be used in this feature.
•
If an incorrect digit was entered, press the [MONI] button and re-enter the whole
number.
•
To exit the tone entry mode, press the [PTT], [SCN], [TA], or [LO] key.
CONFIRM A STORED DTMF CODE
Press the [DIAL] key and then press the [*] key. The LCD display is shown below. Select a
numbered key [0]-[9], the location where the DTMF code is stored. The stored code scrolls on
LCD and corresponding DTMF tone is heard. To return to the original display, press any key.
SENDING A DTMF CODE
To transmit a stored DTMF code, press the [DIAL] key and the memory location [0]-[9]. The
code is displayed on LCD during the transmission.
DELETE A STORED DTMF CODE
To delete a code, press the [DIAL] key and press the [D] key. The LCD display is shown below.
Select the memory location [0]-[9]. To cancel this operation, press any key other than [0]-[9].
RE-DIAL
Pressing the [DIAL] key twice will transmit the last sent DTMF code. The code is displayed on
LCD during the transmission.
NOTE: The Re-dial memory is deleted when the radio is turned off.

CODE SQUELCH

The dealer can program the "code squelch" signaling feature. If this feature is enabled and the
received code is the same as the radio ID code (3-10 digits), squelch opens. If the dealer enables
the "Auto-Responder" and "Call Alert Tone" feature, it can be used with Code Squelch signaling;
but when Group Call is enabled, the "Auto- Responder" feature is inactive.
To send a call, hold down the [PTT] button and enter the ID code or Group Code by the keypad.
The "store and send" or "auto-dial" feature can be used to send codes. When transmission ends,
the radio returns to normal operation.
Note: The "Code Squelch" feature cannot be used with the "selective call" feature on the same
channel.
RELM Communications, Inc. 17