RELM RPV599A Owner's Manual page 10

(5) SPEAKER
(6) MICROPHONE
(7) LCD
Used to display channel and operation status.
(8) SCN KEY
Used to enable or disable the scan function.
(9) LO (low power) KEY
Used to toggle the transmit power mode form "high" to "low" or from "low" to "high".
(10) TA KEY
Used to enable or disable FREQUENCY REVERSE/TALK AROUND feature.
(11) DIAL KEY
When the "store and send" feature is enabled, it is used to send codes; and when
"auto-dial" feature is enabled, it is used to store, confirm, send or delete codes.
(12) KEYPAD
Used to enter, store or send DTMF codes.
(13) PTT BUTTON
Used to switch between transmit and receive mode.
(14) LAMP BUTTON
Used to turn "on" or "off" the LCD backlight. Press the [LAMP] button, the backlight
will illuminate for about 5 seconds and then automatically turn off.
illuminating and pressing any key, except the [LAMP] button, the timer will re-start. To
turn "off" the backlight, press the [LAMP] button again. .
(15) MONI BUTTON
Used to monitor the selected channels.
(16) EXTERNAL SPEAKER-MICROPHONE JACK
Used to connect with external the speaker-microphone, programming cable, or cloning
cable.
(17) BELT CLIP
(18) BATTERY
(19) BATTERY LATCH
10
During
RELM Communications, Inc.