Table of Contents
Advertisement
Quick Links
Download this manual
See also:
User Manual
Advertisement
Table of Contents
Related Manuals for RELM RPV516
Summary of Contents for RELM RPV516
- Page 1 TWO-WAY RADIO Þ ß Ô ² ú RPV516/RPU416 RPV516/RPU416 Owner's Manual Owner's Manual...
- Page 2 OWNER’S MANUAL Thank you! We are grateful that you choose RELM for your land mobile applications . We believe this easy- to-use transceiver will provide dependable communications to keep personnel operating at peak efficiency . Please read and understand this manual carefully for efficient operation.
-
Page 3: Table Of Contents
Battery Save ................9 Low Battery Warning ............10 Monitor ................. 10 CTCSS/DCS ................10 Two Tone Signaling ..............10 Channel Scan ................12 Busy Channel Lockout ............12 Optional Accessories ............13 Troubleshooting ..............13 Frequency Chart ..............14 RELM Wireless Corporation... -
Page 4: User Safety, Training, And General Information
EFFICIENT OPERATION BEFORE USING YOUR RELM HANDHELD PORTABLE TWO-WAY RADIO. Compliance with RF Energy Exposure Standards Your RELM two-way radio is designed and tested to comply with a number of national and international standards and guidelines (listed below) regarding human exposure to radio frequency electromag- netic energy. - Page 5 Use of non-RELM- approved accessories may exceed FCC RF exposure guidelines. • If you do not use a RELM approved body-worn accessory and are not using the radio in the intended use position in front of the face, then ensure the antenna and the radio are kept 2.5 cm (one...
-
Page 6: Fcc Compliance
• Use only RELM approved, supplied batteries or RELM approved replacement batteries. Use of non-RELM-approved batteries may exceed FCC RF exposure guidelines. Approved Accessories For a list of RELM approved accessories see the accessories page of this user manual or visit the following website which lists approved accessories: http://www.RELM.com... -
Page 7: Precautions
OWNER’S MANUAL FCC Requirements Your radio must be properly licensed by the Federal Communications Commission prior to use. Your RELM Wireless dealer can assist you in meeting these requirements. Your dealer will program each radio with your authorized frequencies, signaling codes, etc., and will be there to meet your communications needs as your system expands. -
Page 8: Supplied Accessories
After recharging the battery pack, disconnect it from the charger, otherwise, battery life will be shortened as a result of overcharge. Please turn OFF the power of the transceiver with a battery before charging. Using the transceiver while charging its battery will interfere with proper charging. RELM Wireless Corporation... -
Page 9: Installing/Removing The Battery
Slide the battery pack along the back of the transceiver until the release latch on the base of the transceiver locks . To remove the battery pack , pull back on the release latch and slide the pack away from the transceiver . RELM Wireless Corporation... -
Page 10: Installing The Antenna
Installing Additional Speaker/Microphone Remove the cover of the speaker/microphone jacks,then insert the speaker/ microphone plugs into the speaker/microphone jacks. Note: The transceiver is not fully water resistant while using speaker/ microphone. Getting Acquainted RELM Wireless Corporation... -
Page 11: Basic Operation
11. Battery 12. Battery release latch Basic Operation 1. Switch ON the transceiver by turning the Power/Volume control clockwise untill a beep sounds. 2. To adjust the volume, turn the Power/Volume control knob while pressing the Monitor key. RELM Wireless Corporation... -
Page 12: Auxiliary Functions
While the channel is not busy and no operation is performed for 10 seconds, Battery Save turns ON. When a signal is received or an operation is performed, Battery Save turns OFF. RELM Wireless Corporation... -
Page 13: Low Battery Warning
Two Tone Signaling The Two Tone Signaling (TTS) function is used to control the squelch to turn ON or OFF. It includes two tone call and group call. It can be enabled or disabled by your dealer. RELM Wireless Corporation... - Page 14 After the tones are sent, the squelch switches OFF and the LED indicator flashes orange provided no receive signal is present. • Pressing the MONI key will switch the squelch back ON, thus, muting the speaker audio. RELM Wireless Corporation...
-
Page 15: Channel Scan
PTT causes the transceiver to generate a beep. The transceiver will not transmit in this situation. To stop the beep, release PTT. When this channel is free, press PTT to transmit. RELM Wireless Corporation... -
Page 16: Optional Accessories
•Other group users may be too far away. Make sure you are within range of the other transceiver. •Change CTCSS/DCS tone. Be sure Other voices (Non-group users) are present on the to change the tone on all trans- channel ceivers in your group. RELM Wireless Corporation... -
Page 17: Frequency Chart
OWNER’S MANUAL Frequency Chart Model: Serial Number: Channel Transmit Receive CTCSS/DCS Frequency Frequency RELM Wireless Corporation...