Connection To Power Supply; Installation - Grindmaster Crathco G235-2B Operation And Instruction Manual

Installation (cont.)
4.) Installing the Top Lid Merchandiser (requires Phillips head screwdriver)
• Unplug the cord to the lid and remove the lid from the machine.
• On top of the cover, remove the 4 hole plugs over the front (2) screws,
middle (near rocker switch) and back screws then remove these 4 screws
with a Phillips head screwdriver. Remove the black top part of the cover
from the clear plastic base. (see fig. E)
• Slide the merchandiser header around the outside edge of the lid's clear
plastic base. Position bottom edge of header in grooved area. (see fig. F)
• Reassemble the black top cover onto the clear plastic base. The top edge of
header should slide into black top cover grooved area. (see fig. F) Replace
screws. Replace hole plugs (the angled plugs goes in the rear hole, and the
two large plugs go in the two front holes and the small plug goes in the
center hole by the rocker switches).
• Replace assembled lid on machine and reattach cord.
5. Installing the Rear Back-lit Merchandiser
• To remove any existing artwork, bend or pinch the middle of the back-lit
merchandiser and pull it from the rear merchandising display casing.
(see fig. G)
• To insert new art, slide the left corner edges into the left top and bottom
casing edges. (see fig. H)
• Slightly bend art and insert the right side of art into the right top and bottom
casing edges. (see fig. H)
• Smooth out art until all edges are properly inserted into the casing.
Connection To Main Power Supply
Attention:
!
outlet, carefully read the following precautions.
• The electrical safety of this Granita machine can only be achieved if the machine is properly connected
to an appropriate grounded, electrical receptacle that is in compliance with current national safety stan-
dards. Therefore, the manufacturer cannot be held responsible for damage and/or injury caused by fail-
ure to connect the unit to an appropriate source of power.
• For a safe and correct installation, connect the unit to a dedicated outlet.
• Do not alter the cord or plug in any way.
Attention:
Altering the cord or plug will void the warranty.
!
• The entire length of the power supply cord must not, in any way, be compressed (bent or bunched
together) nor may extension cords be used.
• Do not obstruct the ventilation and heat dispersion grill vents on the side and rear panels of the unit. An
insufficient ventilation process may reduce the efficiency of the machine, causing it to function inade-
quately, and cause serious damage to the machine. A minimum of eight inches (20cm) clearance is
necessary on each side and behind the unit.
G & MG Series Granita Machine
Before inserting the plug into the electrical
(Figure E)
(Figure F)
(Figure G)
(Figure H)
Page 3