Specifications; General; Plumbing - Mira Event XS Installation And User Manual

1. General

1.1. Ambient temperature – Maximum recommended ambient temperature for the
appliance is 30°C.
1.2. Maximum recommended hot water temperature – 65°C.
Warning! For safety reasons set the maximum stored hot water temperature
to between 60 and 65°C. Such temperatures are considered sufficient to meet
all normal requirements and will also minimise the deposition of scale in hard
water areas.
1.3. Temperature control - To obtain full performance the Mira Event XS should
be installed, operated and maintained in accordance with this guide.
1.4. Maximum static inlet pressure - 1 bar or 10 m (supplies must be gravity-fed
at nominally equal pressures). Refer to section: 'Installation Requirements,

Plumbing'.

1.5. Maximum recommended inlet pressure - 0.5 bar or 5 m.
1.6. Minimum static inlet pressure - 0.008 bar or 80 mm (required to prime
the integral centrifugal pump). The minimum static pressure will increase
for long supply pipe lengths. Refer to section: 'Installation Requirements,
Plumbing'.
1.7. Minimum Flow Rate - 8 l/Min (with a static inlet pressure of 0.1 bar).
Maximum Flow Rate - 16 l/Min (with a static inlet pressure of 0.1 bar).
Flow Rates may vary due to differences in supply pressures.
1.8. Duty Cycle - The Mira Event pump is continuously rated. The motor is fitted
with a self-resetting thermal trip, designed to operate if motor temperatures
become too high due to abnormally high supply voltages.
1.9. noise - The Mira Event XS is supplied with anti-vibration rubber feet and rubber
wall plugs that isolate the unit from the wall in order to minimize the amount of
noise transmitted. The type of wall the Mira Event XS is fixed to will also affect
the perceived noise level; solid walls will provide a quieter operation.
2. Plumbing
2.1. Inlet – 15 mm Push-fit inlet manifold.
2.2. outlet – / " BSP to BS2779.
1
2

sPeCIFICATIons

8