LENCO DVP-740 X2 User Manual page 6

Preparation of the Remote Control
Place the remote control on an even surface and insert the supplied button cell into the
remote control as follows.
1. Push the button towards left.
2. Pull the battery loader out.
3. Insert the battery into the recep tacle Make sure the polarity matches the marks
inside the component.
4.Insert the receptacle into the remote control.
Cell data
Battery type: 1x CR2025 , 3 V
Service life: approximately 1 year (for normal use and room temperature)
Using Of Remote Control
Point the remote control towards the main unit when operating.
The remote control works best at a distance less than 5 m and at an angle of up to 30
to the front of the unit. No obstacles may stand in the way between remote control and
infrared sensor and do not place the remote control in direct sunlight. If the remote
control unit fails to work even when it is operated near the player, replace the battery.
Notes on batteries
If the remote control is not used for a long period of time, please remove the battery
from the compartment.
Do not heat batteries or dispose of them in fires.
Do not dismantle, deform or modify batteries.
.
5