Lascal Buggyboard-Maxi Owner's Manual page 5

CONNECTING
9
Click
10
Click
DISCONNECTING
11.
9-10. Connecting the BuggyBoard™.
Unscrew the fixing screws (81340). Adjust
the width of the arms and click the cotter
pins into the connectors, then tighten the
fixing screws. Ensure that the arms are an
equal distance from the centre of the board
and the cotter pins are locked in the connec-
tors.
Leveling the platform.
Unlock the height adjustment screws
(81310) and rotate the platform until level.
Tighten the height adjustment screws.
11. Disconnect the BuggyBoard
At the end of each connector-bolt, slide the
red release buttons down, whilst lifting the
arms up and out of the connectors.
IMPORTANT !
The BuggyBoard must be discon -
nected from the stroller before
folding the stroller.
Do not fold the stroller with the
BuggyBoard attached
- 8 -
WHEN NOT IN USE
12
"Click"
ACCESSORIES
13
14
CLEANING AND RECYCLING
Cleaning instructions: Use warm water with a soft cloth and a mild non-abrasive cleaning
fluid. All BuggyBoard™ parts and packaging are made from recyclable materials.
12. Hooking up the BuggyBoard™.
If the BuggyBoard™ is temporarily not in use,
it can be hooked up behind your stroller. Clip
the hook (81150) onto the platform and atta-
ch the strap to a higher point on your stroller.
13. Accessory: "Extender Kit"
Item no. 11310
To attach the BuggyBoard™ onto certain stro-
llers an 'Extender Kit' may be needed. This
will lengthen each arm up to 6cm (2.4").
The 'Extender Kit' is sold as a pair of exten-
ders.
14. Accessory: Extra Connector Kit
Item no. 11340
If you want to attach the BuggyBoard to ano-
ther stroller/pram without having to remove
the connectors, there is an Extra Connector
Kit available. The Extra Connectors Kit con-
tains a pair.
The use of any accessories with the
BuggyBoard Maxi that have not been
approved by the manufacturer is not
recommended.
- 9 -