Start
Quick set up > Controls at a glance > Rear connectors
Quick set up
Unclip the aerial from the clip on the rear of the radio and fully extend it (steps A and B).
Your power adapter may be supplied with a two-pin European plug. Customers in the UK
should remove and replace with the supplied three-pin UK plug.
Insert the jack of the supplied mains adapter into the socket on the rear of the radio (C).
Stereo Out
Aux In
6V DC
Plug the mains adapter into the mains supply (step D) and press the Standby button.
a) When you see the message 'Enable energy saving?' push the Tune dial.
b) Select 'On' to switch on energy saving mode (push the Tune dial).
Enable energy
saving?
When energy saving mode is switched on, the radio uses less power because it
does not collect and store Intellitext messages in standby. It still collects and stores
Intellitext messages while the radio is switched on.
With energy saving mode switched on, the power consumption of EVOKE Mio in standby
is less than 1 Watt.
For more information: Intellitext
Wait for EVOKE Mio to complete an Autotune for all available DAB stations (this takes
about a minute). When the Autotune is complete, a station will be selected.
EVOKE Mio
Start
2
B
A
1
Now tuning...
Stereo Out
D
C
6V DC
Tune
Energy saving
On
> page 9
energy saving mode
6V DC
Aux In
Tune
> page 13
BBC Radio 2
Talking to the people wh
EcoPlus