Brother MFC-J3520 Quick Setup Manual page 5

f
Gently close the scanner cover using the finger
holds on each side.
CAUTION
Be careful not to pinch your fingers when you
close the scanner cover.
Always use the finger holds provided on each side
of the scanner cover when opening and closing it.
g
Unpack the ink cartridge.
Turn the green release lever on the orange
protective packing a counterclockwise until it
clicks to release the vacuum seal. Then
remove the orange protective packing a as
shown.
IMPORTANT
DO NOT shake the ink cartridges. If ink stains
your skin or clothing, wash with soap or
detergent at once.
h
i
1
IMPORTANT
After initial installation of the ink cartridges, the
machine will start cleaning the ink tube system.
This cleaning process will last approximately four
minutes.
DO NOT unplug the machine from the power
outlet or attempt to stop the cleaning process.
Interruption of cleaning process may cause
undesired print quality problems.
1
Take care to match the sticker colour a with
the cartridge colour b as shown in the diagram
below.
Install each ink cartridge in the direction of the
arrow on the label.
1
2
Gently push the back of the ink cartridge
marked "PUSH" until the cartridge lever lifts.
After all the ink cartridges are installed, close
the ink cartridge cover.
5