Annually Or Every 1,000 Hours; Maintenance Procedures - biodex rtm 600 Operation Manual

CONTENTS

annually or eVery 1,000 hours

reverse exact-track bed
Reverse the Exact-Track bed. The RTM 600 bed is double-sided, allowing it to be reversed and
used over. Once both sides have been used, the bed must be replaced.
replace treadbelt
Inspect Treadbelt for cracks or tears. If none are found, continue to use. If any cracks or tears are
apparent, replace treadbelt.

MaIntenance procedures

belt/deck lubrication
(See Figure 8.4.)
1. Using the large syringe provided, squirt one-half tube of the lubricant underneath the center
of the treadbelt.
2. Walk 10 steps on the RTM 600 at a speed of 1.0 mph. This will moisten an 8" track underneath
the center of the entire treadbelt.
3. Allow the RTM 600 to dry for approximately 10 minutes.
NOTE: Use only the Biodex lubricant kit with your RTM 600. Most standard greases, waxes and silicon
sprays will build up on the rollers, causing belt slippage and affecting tracking.
To re-order lubricant kit, use Biodex part # 945-276. Each container provides 12 applications.
Figure 8.4. Squirt one-half tube of lubricant between the belt and deck.
— 8-3 — MAINTENANCE