User Interface; How To Start Charging - NOCO Genius G750 Owner's Manual & User Manual

10 USING THE G750

USER INTERFACE

MODE BUTTON
The MODE button is
used to select manually
between 6V or 12V
charging modes and
STANDBY.
CHARGE LED
The CHARGE LED indicates
the charging process. The
CHARGE LED will be RED
during the charging process
and will turn GREEN when
the battery is fully charged.
6V MODE LED
The 6V MODE LED (Red) is
illuminated when the battery
charger is in the 6V
charging mode.
WICKED SMART TIP
ERROR CONDITION. An ERROR condition could happen for multiple
reasons. If an ERROR condition occurs, the ERROR LED and CHARGE
LED will blink "on" and "off" at 5Hz. For assistance in resolving
ERRORs, see the section entitled - TROUBLESHOOTING.
Now That's Smart, Wicked Smart.™

HOW TO START CHARGING

1.) Confirm that you have connected the battery clamp or eyelet terminal
connectors properly and the AC power plug is plugged into an electrical outlet.
2.) The battery charger will begin in the STANDBY mode, indicated by a GREEN
ERROR LED
LED. In the STANDBY mode, the battery charger is not outputting any current.
The ERROR LED
By pressing the MODE button, toggle to the appropriate charge mode, either
(Orange) will illuminate
when an error 6V or 12V, to begin the charging process.
condition or reverse
3.) Upon selecting either 6V or 12V charge mode, a RED LED will illuminate the
polarity is present.
selected charge mode and the CHARGE LED (Red) will illuminate indicating the
charging process has started.
4.) When the battery is fully charged, the CHARGE LED will change from RED
to GREEN, indicating the charge process is complete.
5.) The battery charger can be left connected to the battery at all times to
provide maintenance charging. However, it is good practice to check the
12V MODE LED
battery periodically.
The 12V MODE LED
(Red) is illuminated
when the battery
charger is in the 12V
charging mode.
STANDBY LED
The STANDBY LED
(Green) illuminates
when neither charging
mode has been
selected.
WICKED SMART FEATURE
INITIALIZATION. When the battery charger is plugged into an AC
electrical outlet and connected to a battery, there will be a brief (one- to
three-seconds) delay, then all LEDs will light up for a half (1/2) second,
to confirm all LEDs are operational. After the initialization, the only LED
that will illuminate is the last mode selected. If not in STANDBY mode,
the battery charger will begin charging after five (5) seconds. The five (5)
second delay allows time to toggle through the charge modes.
Now That's Smart, Wicked Smart.™
WICKED SMART FEATURE
AUTO-MEMORY. If at any time the battery charger is
disconnected from its power source, either from a power
loss or accidentally disconnecting the AC power plug from
the electrical outlet, the battery charger will remember the
previously selected charge mode when power is restored.
The battery charger will automatically resume the charging
process to ensure your battery is fully charged.
Now That's Smart, Wicked Smart.™
geniuschargers.com
USING THE G750 11
G750