B) Programming Tax via “Flat Tax” procedure (No break point)
CAL
X
REG
Z
1. Turn the PGM key to the PGM position.
OFF
RF
2. Enter the number 3, followed by the s key.
PGM
3. Enter 0125 (for tax table 1) followed by the s key. (Enter 0225 for
tax table 2)
4. Enter your tax rate, followed by the F key. Example: For 6%
enter the number 6. For 5.75%, enter 5.75
5. Enter 5002, followed by the F key.
6. Press the s key to end tax programming.
Example: Set Colorado state tax 5.25%
3
s
P appears in mode display
COLORADO
0125
s
Program code number for tax table 1
5.75%
5^75
F
5.75% tax rate
5.75
5002
F
50 for round off and 02 for Add-on
5002
s
(to end the setting)
Tax status
Your cash register is pre-programmed below.
Department 1 ~ 12: taxable 1 & 2
Department 13 ~: non-taxable
If you need other than this setting for the Department and PLUs,
please refer user’s manual page-57.
User’s manual
5 Daily Management Report
page-43, 74 ~ 79
Read report;
X
CAL
REG
Z
Turn the key switch to the X position and
OFF
press F key.
F
RF
PGM
Reset report;
X
CAL
Z
REG
Turn the key switch to the Z position and
OFF
press F key.
F
RF
PGM
For more detailed report information, refer user’s manual.
For more specific programming options and operating procedures,
that will maximize the benefits of your new cash register, please refer
to you user’s manual or call 800/638-9228 for further assistance.
Thank you for your Casio purchase.