Problem Solving; Reading The Indicators; When The (Warning) Indicator Is Lit Or Flashing - Epson Dreamio EH-TW3600 User Manual

Problem Solving

Reading the indicators

The projector indicates its status using the indicators.
(the icon and the around the button) and
(the icon) light and flash, and
red according to the current status.
The following tables show what the indicators mean and
how to remedy the problems that they indicate.
* If all indicators are switched off, check that the power
cable is connected correctly and that the main power
switch is on.
When the
Internal problem
Red Red
Red Red
Fan problem /
Red
Sensor problem
Lamp problem / Lamp on error
Red
Check if the lamp is broken.
Clean the air filter.
If the lamp is
not broken
If the lamp is
broken
When using above an altitude of about 1500 m, make sure you set the "High Altitude Mode" to
"On".
High internal temperature
Red
(overheating)
The lamp will switch off
automatically and projection will
stop. Wait for approximately 5
minutes. When the cooling fan
stops, turn off the main power
switch at the rear of the projector.
High-speed cooling in
progress
You can continue using the
Orange
projector, but if the temperature
rises again, it will switch off
automatically.
lights and flashes in
(warning) indicator is lit or flashing
p.45
Replace the lamp
and then turn the
power on.
Contact your local dealer or the nearest address provided in the Epson
Projector Contact List.
p.34
: Lit
Disconnect the power cable from the
electrical outlet. Then contact your local
dealer or the nearest address provided in
the Support and Service Guide.
Projector Contact List
p.48
If the problem is still not solved after the lamp is
replaced, stop using the projector and disconnect the
power cable from the electrical outlet. Then contact
your local dealer or the nearest address provided
in the Support and Service Guide.
Projector Contact List
• If the projector is
installed against a
wall, leave a space
of 20 cm or more
between it and the
wall.
• Clean the air filters
if they are blocked.
p.45
(operation) indicator
(warning) indicator
warning/problem
: Flashing
Epson
Epson
If the problem is not solved
when the power is turned
back on, stop using the
projector, turn off the main
power switch, and
disconnect the power
cable from the electrical
outlet. Then contact your
local dealer or the nearest
address provided in the
Support and Service
Guide. Epson
Projector Contact List
: Off
37