Related Manuals for Changzhou Gardensun Furnace HSS
Summary of Contents for Changzhou Gardensun Furnace HSS
- Page 1 IMPORTANT Read this manual carefully before assembling, using or servicing this FOR MODEL: heater. Keep this manual for future reference.
-
Page 2: Table Of Contents
Contents DANGER DANGER indicates an imminently hazardous situation General Safety Information........1 which, if not avoided, will result in death or serious injury. Components & Hardware........WARNING Additional Requirements ........t a l WARNING indicates an imminently hazardous situation which, if not avoided, could result in death or serious injury. Step1 - Attach Wheel Assembly to Base.... - Page 3 DANGER DANGER • EXPLOSION - FIRE HAZARD • Keep solid combustibles, such as building materials, • CARBON MONOXIDE HAZARD paper or cardboard, a safe distance away from the heater • This heater is a combustion appliance. All combustion as recommended by the instructions. appliances produce carbon monoxide (CO) during the •...
-
Page 4: A S S E M B Y L N I T S U R T C O I S N Components & Hardware
Assembly Instructions WARNING Components • This product is fueled by propane gas. Propane gas is invisible, odorless, and flammable. An odorant is normally Remove all components from package. added to help detect leaks and can be described as a Reflector Panel(3) “rotten egg”... -
Page 5: Additional Requirements
WARNING Installation process Assembly time: 0.5 hour California Proposition 65 Combustion by products produced when using (For models without Wheels , skip to Step 2) this product contain chemicals known to the state of California to cause cancer, birth defects, and Step 1 –... -
Page 6: Step 3 -Attach Cylinder Housing To Base
Step 5 – Tabletop Installation Lay Bucket inside of Base and screw on large nut. Put the Plastic nut & Fastening piece through the post Tighten with Philips screwdriver. in order.Put the Tabletop through the post as show. Fill Sand To improve the stability , please fill the bucket with Sand. -
Page 7: Step 7 - Attach Head Assembly To Post
Step 7 – Attach Head Assembly to Post 9 Req’d Small Screw s Screw off 4 small bolts. 4 Req’d Small Bolts Head Assembly Load Head Assembly by inserting hose into post. Insert Head Assembly into post. 9 Req’d Cap Nuts 9 Req’d Small Flat Washers Control knob should be above decal on post. -
Page 8: Step 9 - Attach Reflector Assembly To Studs
Step 9 – Attach Reflector Assembly to Studs The minimum permissible gas supply pressure of 10 W.C. is required for purpose of input adjustment. Support Heater. The minimum hourly of 17000 Btu is required input rating for a Slide 3 Large Flat Washers over threaded end of heater for automatic operation at ratings less than full input rating.