Perimeter Lamps Illuminated Entry - Ford F-350 Owner's Manual

Locks and Security
To reprogram the remote entry
transmitters:
1. Ensure the vehicle is
electronically unlocked.
2. Put the key in the ignition.
3. Cycle eight times rapidly (within
10 seconds) between the 1
(OFF/LOCK) position and 3 (ON).
Note: The eighth turn must end in
the 3 (ON) position. The doors will
lock, then unlock, to confirm that the programming mode has been
activated.
4. Within 20 seconds press any button on the remote entry transmitter.
Note: If more than 20 seconds have passed you will need to start the
procedure over again. The doors will lock, then unlock, to confirm that
this remote entry transmitter has been programmed.
5. Repeat Step 4 to program each additional remote entry transmitter.
6. Turn the ignition to the 1 (OFF/LOCK) position after you have
finished programming all of the remote entry transmitters. Note: After
20 seconds, you will automatically exit the programming mode. The
doors will lock, then unlock, to confirm that the programming mode has
been exited.

Perimeter lamps illuminated entry

With the Remote Keyless Entry system, the following items will
illuminate when the control on the transmitter is pressed:
• Headlamps
• Parklamps
• Tail lamps
The lamps will automatically turn off:
• if the ignition switch is turned to the 3 (ON) position, or
• the Remote Keyless Entry Transmitter lock control is pressed, or
• the vehicle is locked using the keyless entry keypad (if equipped), or
• after 25 seconds of illumination.
Note: On some vehicles, the perimeter lamps illuminated entry feature
will not activate in daylight conditions.
155
2008 F-250/350/450/550 (f23)
Owners Guide (post-2002-fmt)
USA (fus)