NETGEAR MBRN3000 User Manual page 17

To view or manually configure the wireless settings:
Log in to the router as described in
1.
Select Wireless Settings from the main
2.
menu.
The settings for this screen are explained
in Table 3.
Select the region in which the router will
3.
operate.
For initial configuration and test, leave the
4.
other settings unchanged.
To save your changes, click Apply.
5.
Configure and test your computers for
6.
wireless connectivity.
Set up your wireless computers with the
same SSID and wireless security settings
as your router. Check that they have a
wireless link and are able to obtain an IP
address by DHCP from the router. If
there is interference, adjust the channel.
Table 3. Wireless Settings
Settings
Wireless The green radio button shows which network you have selected, the Primary network, or
Network one of three guest networks that you can set up. For help with guest networks, see
settings that you configured in Step 2 are broadcast to the WPS devices so that they can
connect to the router."
Name (SSID)
Region
Channel
Mode
16 | Chapter 2: Wireless Network Configuration
Mobile Broadband Wireless-N Router MBRN3000
"Logging In to Your Router"
Description
on page 22.
The SSID is also known as the wireless network name. Enter a
32-character (maximum) name in this field. This field is
case-sensitive.
When there is more than one wireless network, SSIDs provide a
means for separating the traffic. To join a network, a wireless
computer or device must use the SSID.
The location where the Router is used.
The wireless channel used by the gateway. The default is Auto.
Do not change the channel unless you experience interference
(shown by lost connections or slow data transfers). If this happens,
you might need to try different channels to see which works best.
The default is up to 145 Mbps.
on page 9.
"The