Gravely 927060-1028 Owner's/Operator's Manual page 15

4
5
LEVELING MOWER DECK AND
ADJUSTING MOWER DECK PITCH
Adjust on a level surface, with tires inflated to
correct air pressure (see Specifications on
page 25), and mower lift lever in the middle
position.
Leveling Mower Deck
NOTE: Cutting height should be within 1/4 in.
(6.35 mm) on each side of mower deck
(figure 10).
1. With mower blade(s) (item 3) in line with
discharge chute opening (item 1),
measure distance from bottom of mower
blade(s) to the ground on each side of
mower deck.
2. Perform steps 3 through 5 if the
measurement is too high or too low on
either side of mower deck.
3. Remove rear lift link (item 1) and rear
trunnion (item 2) from unit (figure 11).
• TO RAISE the mower deck, turn rear
trunnion (item 2) clockwise several
turns.
• TO LOWER the mower deck, turn rear
trunnion (item 2) counterclockwise
several turns.
4. Install rear lift link (item 1) and rear
trunnion (item 2) on unit.
3
2
Figure 9
5. Check that the mower deck is level.
• If mower deck is not level, repeat
steps 1 through 4.
• If mower deck is level, then adjust
mower deck pitch.
Mower Deck Shown From The Front
1
5
1. Discharge
Chute Opening
2. Mower Deck
GB - 15
28- and 32-Inch
1
Mower Deck
(927060, 062)
1. Guide Arm
2. PTO Belt
3. Lift Link
4. Mower Deck
5. Electric Clutch
Connector
3
2
4
3. Mower Blade
4. Cutting Height
5. Ground
Figure 10
OE0130
3
OA0009