External Antennas - Cisco Aironet 3600 Series Getting Started Manual

4
Unpacking
To unpack the access point, follow these steps:
Step 1 Unpack and remove the access point and the accessory kit from the shipping box.
Return any packing material to the shipping container and save it for future use.
Step 2
Step 3 Verify that you have received the items listed below. If any item is missing or damaged, contact
your Cisco representative or reseller for instructions.
The access point
–
Mounting bracket (selected when you ordered the access point)
–
Adjustable ceiling-rail clip (selected when you ordered the access point)
–
5
Configurations
The 3600 series access point contains two simultaneous dual-band radios, the 2.4-GHz and 5-GHz
802.11n MIMO radios. The 3600 series access point configurations are:
• AIR-CAP3602E-x-K9—two 2.4-GHz/5-GHz dual-band radios, up to 4 external dual-band
diopole antennas
• AIR-CAP3602I-x-K9—two 2.4-GHz/5-GHz dual-band radios, with integrated dual-band
inverted-F antennas
For information on the regulatory domains (shown as "x" in the model numbers) see
Domains" section on page

External Antennas

The 3602E model is configured with up to four external dual-band dipole antennas, and two 2.4-GHz/
5-GHz dual-band radios. The radio and antennas support frequency bands 2400–2500 MHz and
5150–5850 MHz through a common dual-band RF interface. Features of the external dual-band
dipole antennas are:
• Four RTNC antenna connectors on the top of the access point
• Four TX/RX antennas
These antennas are supported on the 3602E:
• AIR-ANT2524DB-R
• AIR-ANT2524DW-R
6.
"Regulatory
5