Hitachi RAS-13EX9G Instruction Manual page 35

HOW TO EXCHANGE THE BATTERIES IN THE REMOTE CONTROLLER
1
Remove the cover as shown in the figure and
take out the old batteries.
Install the new batteries.
2
The direction of the batteries should match the
marks in the case.
CAUTION
1. Do not use new and old batteries, or different kinds
of batteries together.
2. Take out the batteries when you do not use the
remote controller for 2 or 3 months.
Please operate this switch
only as advised.
RAS13EX9G_EN(25-40).p65
Address Changing Switch
✽ The Address Changing Switch is utilized to avoid
interference between remote controllers when there
are two indoor units mounted in the same room and
is normally not utilized.
(When the device is shipped out of the factory, it is
Switch
set to "A".)
Furthermore, please ask the dealer where the
device was purchased, how the device is configured.
– –
35
35
Push and pull to the
direction of arrow.
3/8/07, 2:46 PM