Operation Indicator; Auto Restart Function - Hitachi RAS-10C9G Instruction Manual

ATTACHING AND REMOVING FRONT PANEL
RECEIVABLE INDICATOR FUNCTIONS

OPERATION INDICATOR

TEMPORARY SWITCH
When the remote control device is not functioning, use the
Temporary Switch mode
(1) When the Temporary Switch is pressed, the unit will
operate as per the previous setting. Should there be
a discontinuation of power supply the unit will operate
as per its automatic setting.
(2) Press the Temporary Switch a second time will stop
the operations of the air conditioner unit

AUTO RESTART FUNCTION

In the event of power failure, the air conditioner will restart
automatically.
In the event of power failure during TIMER operation, the
timer will be reset and the unit will begin or stop operating
under a new timer setting.
G
While gripping both the left and right hand edges
[recessed in the front housing] of the front panel,
lift up to open the front panel.
G
After completion of job, slightly lift up the front
panel and pull down to close the front panel. Ensure
that the 3 sets of left, centre and right clips are
fully secured.
Signal Receivable Window
Timer Lamp
This lamp lights when the timer is working.
Operation Lamp
This lamp lights during operation.
Filter Lamp
When the device is operated for a total of
about 100 hours, the FILTER lamp lights
to indicate that it is time to clean the filter.
The lamp goes out when the POWER
SWITCH set to OFF and ON again.
– 6 –
Temporary Switch On/Off Switch