Kohler Aegis LH775 Service Manual page 87

6. If removed, install rain cap and secure with clamp.
Check position of dust ejector, it should face
downward. Adjust end cap position as required.
5. Connect wires for audible alarm, if used.
Install Radiator Assembly
1. Reassemble components of radiator assembly,
including upper and lower radiator hoses. Rubber
lubricant may be applied to inner surfaces of hoses
to make installation easier. Secure with hose
clamps.
2. Tighten radiator drain plug.
External Engine Components
A Dipstick
E Flywheel Cover
66 690 07 Rev. --
F
E
B Electric Starter
F Radiator Drain Plug
KohlerEngines.com
3. Carefully set radiator assembly into place, guiding
lower radiator hose inside RH support bracket. Make
sure that cooling fi ns do not come in contact with fan
blades as radiator is installed.
4. Position upper radiator support brackets on top of air
cleaner mounting bracket. Install and fi nger tighten
four mounting screws.
5. Connect upper and lower radiator hoses to inlets of
radiator and water pump. Secure with hose clamps.
Make sure tangs of upper clamp face away from fan.
6. Check for adequate clearance between fan and
shroud. Adjust lower radiator supports as required,
then torque four mounting screws to 9.9 N·m
(88 in. lb.).
D
C
C Adapter Plate
Reassembly
A
B
D Oil Drain Plug
87