One-Touch Recording
1.
Choose any Program or a Combi
2.
Hold down ENTER and press REC/WRITE
Triton Le jumps to Record mode, with the REC/WRITE key already armed.
3.
Press START/STOP to begin recording
easier?!
Alternate song method for copying Combis with Arpeggio Patterns
1.
Choose any Combi with the ARP ON/OFF switch on (lit).
2.
Press the SEQ key and create a new song
Confirm OK with F8
REC"
Confirm OK by pressing F8.
3.
Press START/STOP to begin recording
Using the Swing Quantize function
1.
Press MENU
Press F5, then CURSOR ▼to T Edit
first four measures as a region to edit (from M:001 to End of M:004).
2.
Press F8 Utility and CURSOR to Quantize
and DIAL (or type in, pressing Enter after) a swing percentage and press F8, OK.
Sampling with the EXB-SMPL Option
The user-installable EXB-SMPL sampling option provides the user with everything needed for serious sampling: a
pair of audio inputs with Level control and Mic/Line level switching, a SCSI connector, and 16 MB of Sampling
RAM.
The Triton LE samples at 48 kHz, 16-bit, in mono or stereo. With the provided 16 MB, the Triton LE is capable of
recording samples of 174 seconds @ mono, or 87 seconds @ stereo. Fully expanded with SIMM modules to 64 MB,
it allows about 11 ½ mono minutes or 5.8 stereo minutes of sampling! The correct SIMMS are 72-pin, non-parity,
EDO or Fast Page (FPM) DRAM SIMM, 60 ns (nanoseconds) or faster, 11 Bit Addressing.
Recording "one-shot" vocal samples
1.
Connect a microphone to the AUDIO INPUT 1 jack on the rear panel, set the MIC/LINE switch to MIC, and
set the LEVEL control to the 12 o'clock position.
2.
Press the SAMPLING key
new MS____000"
value of "C2". The easiest way to set this is by holding down the ENTER key and pressing the C2 key on
the keyboard.
3.
Press F3 ("In/Pref")
numeric keypad (Enter 6 > 4, followed by pressing the ENTER key).
4.
CURSOR ► to "Input 1 BUS"
"Range" value to "001".
5.
Press F2 ("Rec"), and in "Sample Setup", CURSOR ► to "Mode" and set to "L-Mono".
Tap the TIMBRE/TRACK key at least 3x to enter a desired tempo.
Press F8 to answer "OK" to "Setup to Record: Are you sure?"
Press START/STOP again to stop recording. What could be
Press F8, Utility and CURSOR to "Copy from Combi"
CURSOR to and check both boxes "with Effects" and "Auto Adjust Arp for Multi
Press START/STOP again to stop recording.
Press F8 to confirm OK
Press F1 ("Sample" tab) and make sure that "MS" (Multisample) is set to "000:
CURSOR to, and set both the "Orig K" and "Top K" (original and top key) fields to a
CURSOR ► to "Input 1 Pan", and set this value to "C064" with the DIAL or
Set this value to "L/R"
Press F8 to Open
Select a Track to edit; select the
Set Resolution to the 16
CURSOR to the "Create" edit cell and set the
5
TRITON Le EasyStart
th
note icon,
Need help?
Do you have a question about the TRITON Le and is the answer not in the manual?