Diagnostic M&C Software Installation & Use; Progterm Diagnostic M&C Software; Progterm Software Installation - Sea Tel DAC-2202 Installation And Operation Manual

DAC-2202 Antenna Control Unit
7. Diagnostic M&C Software Installation & Use
In an ongoing effort to aid our Dealer Technicians in troubleshooting and ease of Software Uploading, Sea Tel makes available
two proprietary M&C diagnostic software's (ProgTerm and DacRemP) as well as one 3
Utility. All three of these programs may be found on the diagnostic support disk provided with every antenna system or it is
also located on the dealer support site. The following chapter has been written to describe the software installation, the
electrical hookup, and functional usage process'.
7.1. ProgTerm Diagnostic M&C Software
ProgTerm (Sea Tel Program Terminal) is a terminal program that may be used to:

Configure all above decks or below software parameter(s), including by not limited to enabling port security.

Download and/or Upload Software parameter dump log files.

Perform software updates to above decks or below decks equipment.

Aid in communication fault diagnostics.

Auto-Discover all local and remote systems that are on the same network as client computer.
The following text describes the installation and use of this program. NOTE: It is highly recommended that only a
qualified technician perform any of the below procedures as an incorrectly set value may render your system
inoperable. Any failures caused by an incorrect parameter setting will NOT be covered as part of the limited warranty
policy.
7.2.

ProgTerm Software Installation.

A copy of the ProgTerm Installation program may be found on the Diagnostic Support disk provided with the Antenna.
Double Click on the ProgTerm_Install_1.xx.exe
filename. Where xx represents the current
software revision.
This will bring up the WinRaR self-extracting
archive dialog box.
Although not recommended, click on the
"Browse" button to bring up a dialog box to
browse through you computer and select a
different Destination folder in which you wish to
have the program installed.
Once the desired Destination folder has been
selected click on Install to begin the installation
process.
Diagnostic M&C Software Installation & Use
7-1
rd
party software known as SHD Network