Speaker Placement - Wharfedale Pro Titan 8 Passive Operating Manual And User Manual

OPERATING MANUAL AND USER GUIDE
SETTING UP
1. Ensure the speakers power switch is in the off position (Active models only)
2. Set the level controls to minimum (Fully anticlockwise) (Active models only)
3. Set the EQ controls to 0dB (Active models only)
4. Select mic/line input (Active models only)
5. Connect all signal cables
6. Connect the power cable (Active models only)
7. Switch on source equipment, ensuring that the master level is at minimum
8. Switch on the Titan Loudspeaker (Active models only)
9. Raise the level control on the Titan (Active models only) or external amplifier
10. If the limit LED illuminates lower the level control, if more level is required you will need more
speakers. Occasional flashes are acceptable. (Active models only)
11. When powering down your system ensure that the level control (Active models only) has been
lowered to minimum before switching off the power

SPEAKER PLACEMENT

The well behaved dispersion characteristics of the Titan series make speaker placement quick and
simple.
As with all full range loudspeakers it is recommended to place a Titan above the head level of the
audience, as the human body can absorb a huge amount of high frequency energy. Placing the
loudspeaker enclosure higher up also helps improve coverage for more even levels over a greater
audience area.
Tripod speaker stands, pole mounts, Wall brackets and rigging hardware can be used to elevate the
Titan loudspeaker. Always ensure that any accessories that are used are capable of safely elevating
the loudspeaker as incorrect rigging can be dangerous and even fatal. Please refer to the important
safety warnings section for more guidelines on rigging and suspending.
Always place your microphones outside the coverage of your front of house speakers to reduce the
risk of feedback.
7