Wharfedale Pro Titan 8 Passive Operating Manual And User Manual page 14

OPERATING MANUAL AND USER GUIDE
TITAN™ 8A MKII/12D/15D REAR PANEL FEATURES
Heat Sink:
1.
of the enclosure. (Titan 8A MKII and 15D only)
VOLUME for INPUT A and INPUT B:
2.
master volume on the Titan 8A MKII)
HI and LOW EQ (equalization) controls:
3.
signal providing +/- 10dB of gain for each band.
Remote Control:
4.
90Hz Monitor Filter switch:
5.
Horn LED defeat switch:
6.
RCA L / R (Left and Right) input jacks:
7.
signal is actively combined or "summed" providing a mono signal to the amplifier.
GAIN selection switch:
8.
connected to INPUT A, use mic mode (up). If the signal source is anything other than a microphone (playback
device, keyboard or mixer output, for instance) use the line mode (down) .
9 & 10.
switch: turns the power on and off. The bracketed LED to the left of the POWER switch illuminates when the
power switch is in the´ON´ position. The LIMIT LED illuminates when the signal limiter is limiting the level of
the signal to prevent distortion and overload.
Output source "LOOP / MIX" switch:
11.
the line level XLR OUTPUT jack, bypassing the EQ section and volume control. When in the MIX mode, this
switch routes the combined (or "mixed") signals of both INPUT A and INPUT B to the line level XLR OUTPUT
jack.
XLR / ¼" COMBO input jacks for INPUT A and INPUT B:
12.
balanced input connections to INPUT A and INPUT B
POWER cord receptacle:
13.
connection cord. Be sure that you are plugging into the correct source voltage that matches what is indicated
just below the power cord jack.
XLR line level OUTPUT jack:
14.
Titan™ ACTIVES, powered subwoofers or amplifiers.
13
The heat sink allows for dissipation of heat built up from the amplifier via air cooling at the rear
This Pheonix connector can be used to control the volume with an applied voltage.
Used to reduce bass buildup due to half space loading.
Switches off the horn power LED for discrete applications.
This switch selects the proper gain structure for INPUT A. If a microphone is
POWER ON / OFF switch, POWER ´ON´ indicator LED and LIMIT indicator LED:
This is a receptacle for a standard IEC, three prong, grounded AC electrical
This jack provides a balanced line level output for connection to additional
These knobs control the level of each input channel (Controls the
These knobs control the equalization of the overall output
These jacks allow input of a stereo signal (left and right). The
In the "LOOP" mode, this switch routes the signal of INPUT B to
These convenient jacks allow XLR or ¼"
The