Wharfedale Pro Titan 8 Passive Operating Manual page 14

OPERATING MANUAL AND USER GUIDE
TITAN™ 8/12/15 ACTIVE REAR PANEL FEATURES
Heat Sink:
1.
of the enclosure.
HI and LOW EQ (equalization) controls:
2.
signal providing +/- 10dB of gain for each band.
POWER ´ON´ indicator LED and LIMIT indicator LED:
3.
switch illuminates when the power switch is in the´ON´ position. The LIMIT LED illuminates when the signal
limiter is limiting the level of the signal to prevent distortion and overload.
VOLUME for INPUT A and INPUT B:
4.
the master volume on the Titan 8A MK2)
POWER ON / OFF switch:
5.
RCA L / R (Left and Right) input jacks:
6.
signal is actively combined or "summed" providing a mono signal to the amplifier.
BRO™ Bass Response Optimizer circuit switch:
7.
enhanced low frequency response at lower volume levels.
GAIN selection switch:
8.
connected to INPUT A, use mic mode (up). If the signal source is anything other than a microphone (playback
device, keyboard or mixer output, for instance) use the line mode (down) .
Output source "LOOP / MIX" switch:
9.
the line level XLR OUTPUT jack, bypassing the EQ section and volume control. When in the MIX mode, this
switch routes the combined (or "mixed") signals of both INPUT A and INPUT B to the line level XLR OUTPUT
jack.
XLR / ¼" COMBO input jacks for INPUT A and INPUT B:
10.
balanced input connections to INPUT A and INPUT B
POWER cord jack:
11.
Be sure that you are plugging into the correct source voltage that matches what is indicated just below the
power cord jack.
XLR line level OUTPUT jack:
12.
Titan™ ACTIVES, powered subwoofers or amplifiers.
13
The heat sink allows for dissipation of heat built up from the amplifier via air cooling at the rear
These knobs control the volume of each input channel (Controls
This switch: turns the power on and off.
This switch selects the proper gain structure for INPUT A. If a microphone is
In the "LOOP" mode, this switch routes the signal of INPUT B to
This is a jack for a standard IEC, three prong, grounded AC electrical connection cord.
This jack provides a balanced line level output for connection to additional
These knobs control the equalization of the overall output
The bracketed LED to the left of the POWER
These jacks allow input of a stereo signal (left and right). The
The BRO™ circuit, when engaged, allows for
These convenient jacks allow XLR or ¼"