Firewall; Access Control - AirTies RT-205 User Manual

To complete setting up your Mesh network for each access point device you like this RT-205 to
connect to you specify this RT-205 as an access point.
The access points you have chosen must use the same wireless channel as your RT-205 modem.
To set the wireless channel of the access point device, go to "Settings" under the "Wireless" menu
of the web interface of the device.

Firewall

5.
A firewall is the primary method for keeping a computer secure from intruders. A firewall allows
or blocks traffic into and out of a private network or the user's computer.
One of the methods used by the Airties RT-102 firewall to protect your network is SPI, Stateful
Packet Inspection. SPI monitors the protocol and packet addresses being received to determine
if the information should be passed through the firewall to the connected computers. The Internet
addresses that are a source of malicious attacks are permanently blocked from accessing your
network.
You can also limit or block the Internet access of any local user by defining advanced rules.
To activate the fı'ddrewall, go to "FIREWALL" under the left menu bar of the RT-205 web interface.
Check the "Firewall is Active" box and click "Save".

Access Control

5.1
You can allow or block a user's access to certain Internet services by setting MAC or IP address
filters.
Go to "Access Control" under the "FIREWALL" menu in the left menu bar of the Web interface.
Check the "Activate Access Control" box. Click "New" to define a new access restriction. This
will put you in the "IP Filters" window.
17
AirTies RT-205 User Manual Rev.0.1