Memory Upgrade Module; Installing Memory Upgrade Modules - Fujitsu LIFEBOOK S752 User Manual

Memory Upgrade Module

Your Fujitsu LIFEBOOK notebook comes with a minimum of 2 GB of high speed Double Data Rate Synchronous Dynamic
RAM (DDR3-1600 SDRAM) factory installed. To increase your notebook's memory capacity, you may install an additional
memory upgrade module. The memory upgrade must be a dual-in-line (DIMM) SDRAM module. To ensure 100%
compatibility, purchase the SDRAM module only from the Fujitsu web store at www.shopfujitsu.com
•
D
O NOT REMOVE ANY SCREWS FROM THE MEMORY UPGRADE MODULE COMPARTMENT EXCEPT THE ONES SPECIFICALLY SHOWN IN THE DIRECTIONS
FOR INSTALLING AND REMOVING THE MEMORY UPGRADE MODULE
•
T
HE MEMORY UPGRADE MODULE CAN BE SEVERELY DAMAGED BY ELECTROSTATIC DISCHARGE
THE FOLLOWING PRECAUTIONS
- B
EFORE HANDLING A MEMORY MODULE
- W
HEN INSTALLING OR REMOVING A MEMORY MODULE
TO TOUCH ANY INTERNAL COMPUTER TERMINALS OR COMPONENTS
- B
E SURE TO POWER DOWN YOUR SYSTEM BEFORE ADDING OR REMOVING MEMORY MODULES
STATES

Installing Memory Upgrade Modules

Turn off power to your notebook, remove any power adapter (AC or auto/airline). Remove the battery.
1
Make sure that all the connector covers are closed.
2
Turn the notebook bottom side up, remove the screw from the memory upgrade module compartment, and
3
remove the cover. (Figure 23)
Remove the new memory upgrade module from the static guarded sleeve.
4
Align the memory upgrade module with the part side up. Align the connector edge of the memory upgrade
5
module with the connector slot in the compartment.(Figure 24)
:
,
,
DATA COULD BE LOST OR THE MEMORY COULD BE DAMAGED IF POWER IS STILL AVAILABLE TO THE SYSTEM
.
TOUCH A GROUNDED METAL OBJECT TO DISCHARGE STATIC ELECTRICITY BUILT UP IN YOUR BODY
,
HOLD IT BY THE EDGE SO AS NOT TO TOUCH ANY CONTACTS OR CHIPS
;
THE OIL FROM YOUR FINGERS COULD CAUSE A SHORT TO THE COMPONENTS
73
.
(ESD). T
O MINIMIZE RISK TO THE MODULE
. E
VEN IF THE SYSTEM IS IN HIBERNATE OR SLEEP
.
,
OBSERVE
.
. B
E CAREFUL NOT
.