Syncing The Remote To Your Helicopter - Brookstone u Control Instructions Manual

sYncinG The ReMoTe To YouR helicoPTeR

When you and your friends are flying several helicopters in the same room
simultaneously, different channels need to be selected for each helicopter to avoid
signal interference. Steps 1-4 will need to be followed every time you fly.
ImPOrtANt: make sure you sync each remote to each helicopter one at a time.
the second helicopter must be off during the syncing process.
1. Turn the remote on by moving its ON/OFF SWITCH to ON.
2. Turn on the helicopter by sliding its ON/OFF SWITCH to ON.
3. Decide the channel on which you'd like your helicopter to run and move the
CHANNEL SWITCH to A or B.
4. Slowly push the THROTTLE forward once, and then return it to its original position.
This will sync the channel you selected to your helicopter. The blinking red light on
the copter will shine solid when syncing is complete.
5. Push the THROTTLE forward a second time. The blades will begin to rotate. This
confirms you have successfully synced the helicopter with a channel.
Note: you will need to re-sync your helicopter to the remote after shutting both
the remote and the helicopter off, and when you charge the helicopter's battery
or change the batteries in the remote.
8