Attaching And Removing The Headset From The Helmet Clamp; Using The Headset; Using The Intercom - Cardo Systems SCALA RIDER Q2 PRO User Manual

ATTACHING AND REMOVING THE
HEADSET FROM THE HELMET CLAMP
ATTACHING:
Slide the headset downwards along the
sliding panel until a clicking sound
indicates that the headset is locked in
place.
REMOVING:
Your headset can be removed for charging
and storage by pressing your finger
gently against the tab and sliding the
headset up with the other hand.
We recommend that you remove the
headset from the helmet when not in use.

USING THE HEADSET

GENERAL USAGE
GENERAL FUNCTIONS
DESIRED RESULT:
Turn on the headset
Turn off the headset
Increase the volume
Decrease the volume
AGC (Automatic Gain Control): In addition to manual Volume Control,
the scala rider Q2 will automatically increase and reduce its
pro
volume according to ambient noise and driving speed.
Press here
to remove
REQUIRED ACTION:
Press the CTRL Button steadily for at least
three seconds
Press the CTRL Button steadily for at least
three seconds
Tap the Volume Up Button
Tap the Volume Down Button
AUDIO SOURCES AND PRIORITIES
The different Audio Sources that are connected to the scala rider Q2
are prioritized as follows:
pro
Highest 1. Mobile phone Audio / GPS device (Incoming/outgoing calls ,
GPS audio and navigation instructions)
2. Primary Buddy Audio and Secondary Buddy Audio
3. A2DP audio source
4. FM Radio (built-in)
Lowest 5. MP3 Connectivity (corded connection)
A high priority Audio Source will always interrupt any lower priority
Audio Source.
i.e. Mobile phone call interrupts Intercom call
Intercom call interrupts FM Radio

USING THE INTERCOM

Making Intercom calls
To start a Buddy Intercom call with the Primary Buddy while
the headset is on Standby you can either:
VOICE CONNECT:
Start talking
A Buddy Intercom call will be
established and stay on until
both sides are quiet for 30
seconds.
To start a Buddy Intercom call with the Secondary Buddy
while the headset is on Standby:
or
MC BUTTON CONNECT:
Single tap the MC Button
A Buddy Intercom call will
be established. To end the
Buddy Intercom call, single
tap the MC Button again.
scala rider ® Q2
™ 9
pro