Connecting Com2 Connector; Wol (Wake On Lan) Connector - AOpen DXPN-U Easy Installation Manual

6. Advanced 64-bit PCI-X Slots
DXPN-U provides four 64-bit/66/100MHz PCI-X and one 32-bit/33MHz PCI slots. The
64-bit/66/100MHz PCI-X slots maximizes I/O bandwidth for the next generation 64-bit PCI-X
cards that support 100MHz bus. The PCI-X specification 1.0a allows full peer-to-peer
transactions between PCI buses and provides options for intelligent I/O and server
management cards.
32bit/33MHz PCI Slot
64bit/66/100MHz
PCI Slots

7. Connecting COM2 Connector

This motherboard provides two serial ports. One of them is on back panel connector, and
the other is on the upper middle of board. With proper cable, you can connect it to the back
panel of chassis.
8. Connecting Multi Function Panel Connector
Attaching such as power switch, reset switch, HDD LED connector, etc to corresponding
pins.

9. WOL (Wake on LAN) Connector

To use Wake On LAN function, you must have an Ethernet card with chipset that supports
this feature, and connect a cable from LAN card to motherboard WOL connector. The
system identification information (probably IP address) is stored on network card and
because there is a lot of traffic on the Ethernet, you need to install network management
software, such as ADM, for the checking of how to wake up the system.
+5VSB
GND
LID
WOL connector
1
Intruder
Power Switch
ACPI & Power LED
IDE LED
External NMI
Speaker
Reset