Connecting Ide And Floppy Cables; Connecting Front Panel Cable - AOpen MX3W-E2 Easy Installation Manual

6. JP23 FSB/PCI Clock Ratio
This jumper is used to specify the relationship of PCI and FSB clock. Generally
speaking, if you are not overclockers, we recommend you to set at the default setting.
JP23 FSB Select
Jumper
7. Install DIMM Modules
This motherboard has two 168-pin DIMM sockets that allow you to install PC100 or
PC133 memory up to 512MB. The MX3W-E2 supports both Non-ECC and ECC Register
SDRAM Modules.
JP23
1 1
FSB=122~160MHz
Auto (Default)
1 1
FSB=95~166MHz FSB=66.6~80MHz
Warning: Higher CPU FSB frequency may be
able to increase CPU speed, but you may damage
the CPU or reduce the CPU lifecycle.
DIMM1
DIMM2

8. Connecting IDE and Floppy Cables

Connect 34-pin floppy cable and 40-pin IDE cable to floppy connector FDD and IDE
connector. The blue connector is IDE1 for clear identification. Be careful of the pin1
orientation. Wrong orientation may cause system damage.
FDD Connector
Pin 1

9. Connecting Front Panel Cable

Pin 1
Attach the power LED, speaker, and reset switch connectors
to the corresponding pins. If you enable "Suspend Mode" item
in BIOS Setup, the ACPI & Power LED will keep flashing while
the system is in suspend mode.
Locate the power switch cable from your ATX housing. It is
2-pin female connector from the housing front panel. Plug this
connector to the soft-power switch connector marked SPWR.
Secondary
Slave (4th)
ATA 33/66/100 IDE
Connector
Pin 1
Primary
Slave (2nd)
1
KEYLOCK -
IDE LED
+
+
Speaker
1
GND
LEDPWR
+5V
IDE LED
IDE LED
+5V
+5V
GND
NC
SPEAKER
Secondary
Master (3rd)
Primary
Master (1st)
+
SPWR
+ ACPI & PWR
LED
+
Reset
5VSB
PWRBTI
ACPI LED -
GND
ACPI LED
NC
NC
GND
RESET
GND