Bosch DINION IP imager 9000 HD User Manual page 7

Rugged, active infrared surveillance camera
Hide thumbs Also See for DINION IP imager 9000 HD:
Table of Contents

Advertisement

7 | DINION IP imager 9000 HD
Video streaming
Video compression
H.264 (MP); M- JPEG
Streaming
Multiple configurable streams in H.264
and M-JPEG, configurable frame rate and
bandwidth.
Regions of Interest (ROI)
Overall IP Delay
Min. 120 ms, Max. 240 ms
GOP structure
IP, IBP, IBBP
Encoding interval
1 to 25 (30) ips
Resolutions (H x V)
• 1080p HD
1920 X 1080
• 720p HD
1280 x 720
• D1 4:3 (cropped)
704 x 480
• SD upright
400 x 720
(cropped)
• 480p SD
Encoding: 704 x 480;
Displayed: 854 x 480
• 432p SD
768 x 432
• 288p SD
512 x 288
• 240p SD
Encoding: 352 x 240;
Displayed: 432 x 240
• 144p SD
256 x 144
Audio
Compression
AAC, G.711, L16 (live and recording)
Signal-to-noise ratio
> 50 dB
Audio Streaming
Full duplex / half duplex
Local storage
Internal RAM
10 s pre-alarm recording
Memory card slot
Supports up to 32 GB microSDHC / 2TB
microSDXC card. (An SD card of Class 6
or higher is recommended for HD
recording)
Recording
Off / continuous / events / schedule
recording
Audio / metadata recording selectable
Network
Protocols
IPv4, IPv6, UDP, TCP, HTTP, HTTPS,
RTP/RTCP, IGMP V2/V3, ICMP, ICMPv6,
RTSP, FTP, Telnet, ARP, DHCP, SNTP,
SNMP (V1, MIB‑II), 802.1x, DNS,
DNSv6, DDNS, SMTP, iSCSI, UPnP
(SSDP), DiffServ (QoS), LLDP, SOAP,
Dropbox, CHAP, Digest Authentication.
Encryption
TLS 1.0, SSL, DES, 3DES, AES
(optional)
Network
Ethernet
10/100 Base-T, auto-sensing, half/full
duplex
Ethernet connector
RJ45
Connectivity
ONVIF Profile S, Auto-MDIX
Software control
Unit Configuration
Via web browser or Configuration
Manager
Software update
Remotely programmable
Input/output
Analog Video out (service
CVBS (PAL/NTSC), 1 Vpp, BNC, 75 Ohm
only)
(non-protected)
Audio
1 x mono line in, 1 x mono line out
• signal line in
12 kOhm typical, 1 Vrms max
• signal line out
1 Vrms at 1.5 kOhm typical,
Alarm
1 input
• activation voltage
Tolerant from +5 VDC to +40 VDC
(+3.3 VDC with DC-coupled 22 kOhm
pull-up resistor)
Alarm
1 output
• voltage
30 VAC or +40 VDC max.
Maximum 0.5 A continuous, 10VA
(resistive load only)
Lens
Lens type
10 to 23 mm Automatic Varifocal (AVF)
SR lens
Infrared performance
IR corrected
Adjustment
Motorized zoom/focus
Iris control
Automatic iris control
Viewing angle (10 to
Wide: 34º x 18º (H x V)
23 mm)
Tele: 14.8º x 8.3º (H x V )
Night vision
Distance
120 m (394 ft) max.
LEDs
7 High efficiency LED array with Variable
Field Illumination
Beam Patterns (H x V)
Wide beam: 42° x 20° (with 3D diffuser)
Narrow beam: 10° x 10°
Wavelength
850 nm
Intensity Adjustment
31 step adjustments from min. to max.
On/ Off control
Slave to camera mode
Manual on/ off control via IP Interface
Illumination Tilt
Maximum: 13° tilt above camera axis
Adjustment
Minimum: 3° tilt above camera axis

Advertisement

Table of Contents
loading

Table of Contents