Clutch Housing; Engine - Graco GMax 308870 Instruction & Repair Manual

Removal
1. Fig. 12. Remove four capscrews (75) and lock-
washers (77) which hold clutch housing (5) to

engine.

2. Remove screw (15) from under mounting plate (D).
3. Remove engine key (7).
4. Pull off clutch housing (5).
Installation
1. Fig. 12. Push on clutch housing (5).
2. Install four capscrews (75) and lockwashers (77)
and secure clutch housing (5) to engine. Torque to
200 in-lb (22.6 N m).
3. Install capscrew (15) from beneath mounting
plate (D). Torque to 26 ft-lb (35.2 N m).
Removal
1. Remove Pinion Assembly/Rotor/Field/Pinion/
Clutch, Clamp and Clutch Housing, as in-
structed on pages 7, 9 and 10.
2. Fig. 13. Disconnect all necessary wiring.
3. Fig. 14. Remove two locknuts (71) and screws
(70) from base of engine.
4. Lift engine carefully and place on work bench.
NOTE: All service to the engine must be performed by
an authorized HONDA dealer.
87
Green
Fig. 13

Clutch Housing

Fig. 12
Engine
71
Fig. 14
Installation
1. Lift engine carefully and place on cart.
2. Fig. 14. Install two screws (70) in base of engine
3. Fig. 13. Connect all necessary wiring.
To the field
To the engine
4. Install Pinion Assembly/Rotor/Field/Pinion/
9027A
7
15
70
71
and secure with locknuts (71). Torque to 200 in-lb
(22.6 N m).
Clutch, Clamp and Clutch Housing, as
instructed on pages 7, 9 and 10.
5
77
75
D