Before You Start; Connecting Your Logitech Headset - Logitech Bluetooth Headset User Manual

Using your Bluetooth headset with the Logitech wireless hub

Before you start

Before you use your Bluetooth headset with your wireless hub, confirm that:
•
You have installed your Logitech product, the SetPoint™ software, and Easy
Synchronization. As part of the SetPoint installation the WIDCOMM
(stack) is installed. Most versions of the WIDCOMM
details of compatible versions are listed in the installation guide, provided at
www.logitech.com/bluetooth/installation.
This guide assumes that you are using the WIDCOMM
than a different manufacturer's stack; if you prefer to use a different stack refer to the
manufacturer's help system for instructions.
•
You are using the Bluetooth
an equivalent configuration – see
•
You have charged your headset, so it is ready for use.
This guide contains all the information you need to connect and start using your Bluetooth
headset. If you need further information, additional sources are available:
•
www.logitech.com/bluetooth
•
www.logitech.com/bluetooth/installation
•
www.logitech.com/bluetooth/howto
products that have been tested and approved for use with the Logitech wireless hub.

Connecting your Logitech headset

This section describes how to connect using the WIDCOMM
are using Microsoft
refer to the Windows
To connect your Logitech headset and computer:
1 Place your headset in discoverable mode. To do so, with the Logitech headset turned off,
press and hold the button on the side of your headset for up to 10 seconds until its indicator
light first flashes blue three times, and then fast blue and red.
Please note:
•
•
© 2005 Logitech, Inc.
®
wireless hub supplied with your Logitech product or you have
provides general information about the Bluetooth
® ®
Windows XP Service Pack 2 and prefer to use its built-in Microsoft
®
Help and Support Center for connection instructions.
If the indicator light flashes red three times and then stops flashing, this means that
the headset was turned on when you began, and you have now turned it off.
Release the button and start again.
For the Motorola Bluetooth Headset, with the headset's boom open, press and
hold the multifunction button for three seconds. For other headsets, press and hold
the button for several seconds. Refer to your headset's user guide for full details.
®
Bluetooth
®
Bluetooth
www.logitech.com/bluetooth/installation
explains how to install Logitech
provides a product compatibility matrix which lists the
®
Bluetooth
® ®
Bluetooth software
®
stack are supported;
®
software (stack) rather
for details.

technology.
®
devices and software.
®
stack. However, if you
®
stack,
3