Avocent AMX Series Installer/User Manual page 24

18
AMX Series Installer/User Guide
Connecting users to the AMX
Once all servers are connected, you can begin to connect users. Users are
connected to the AMX system through the AMX user station.
AC Power Connection to
AMX Switch
Figure 2.8: AMX5100 User Station Rear Panel
Connections to
AC Power
AMX Switch /
Local Server
Figure 2.9: AMX5110/AMX5120 User Station Rear Panel
To connect users to the AMX system:
1. Place the AMX user station near the monitor you wish to connect. Each
unit is designed to bear the weight of a monitor and can be used as a
monitor stand.
2. Plug your keyboard, monitor and mouse cables into the appropriate ports
on the back of the user station.
3. Connect one end of a UTP cable into the RJ-45 port on the user station.
Route the cable to your AMX5000 or AMX5010 unit and connect the other
end to one of the available RJ-45 user ports.
NOTE: Either RJ-45 port on the AMX5110 or AMX5120 user station can be used to connect
to the AMX switch. Connections to two separate AMX switches are not supported on the
AMX5110 and AMX5120 user stations.
KVM Access
KVM Access
Serial Port