Fft Fine Finish Rac Spray Tips; Wrx Widerac Spray Tips - Graco 311001G Instructions And Parts List

Spray Tip Selection Chart
RAC SwitchTips, for use with AA Series Air Cap Continued
• All tips in the Spray Tip Selection Charts below
can be used with Model 249238 G40 guns
equipped with RAC air cap 288465.

FFT Fine Finish RAC Spray Tips

Order desired tip (Part No. FFTxxx) from matrix below.
* Fluid Output, fl oz/min (lpm) ❖ Maximum Pattern Width at 12 in. (305 mm)
Orifice Size in. at 2000 psi
(mm) (14.0 MPa, 140 bar)
0.008 (0.203) 8.8 (0.26)
0.010 (0.254) 13.9 (0.41)
0.012 (0.305) 19.9 (0.59)
0.014 (0.356) 27.0 (0.80)

WRX WideRAC Spray Tips

Order desired tip (Part No. WRXxxx) from matrix below.
* Fluid Output,
fl oz/min (lpm)
Orifice Size in. at 2000 psi
(mm) (14.0 MPa, 140 bar)
0.021 (0.533) 60.5 (1.79)
0.023 (0.584) 72.7 (2.15)
0.025 (0.635) 85.9 (2.54)
0.027 (0.686) 100.0 (2.96)
0.029 (0.737) 115.6 (3.42)
0.031 (0.787) 131.8 (3.90)
0.033 (0.838) 149.4 (4.42)
0.035 (0.889) 168.3 (4.98)
0.037 (0.940) 187.9 (5.56)
0.039 (0.991) 208.9 (6.18)
* Tips are tested in water.
Fluid output (Q) at other pressures (P) can be calculated by this formula: Q = (0.041) (QT)
where QT = fluid output (fl oz/min) from the above table for the selected orifice size.
❖ Measured with NO airflow. Air assist will tend to reduce pattern lengths by 1 in. to 2 in.
32
4 to 6 6 to 8 8 to 10
(150) (200) (250)
208 308
210 310 410
212 312 412
214 314 414
❖ Maximum
Pattern Width at
12 in. (305 mm)
24 in.
(610)
1221
1223
1225
1227
1229
1231
1233
1235
1237
1239
10 to 12 12 to 14
(300) (350)
510
512 612
514 614
P
311001G