Table of Contents
Advertisement
Quick Links
T1-Titanium
Non-HVLP Spray Gun
Important Safety Instructions
Read all warnings and instructions in this manual.
Save these instructions.
Maximum Fluid and Air Inlet Pressure:100 psi (0.7 MPa, 7 bar)
II 2 G
Gun Part
Needle/Nozzle
No.
5430
5435
* At 50 psi (345 kPa, 3.4 bar)
SHARPE MANUFACTURING COMPANY • P.O. BOX 1441, MINNEAPOLIS, MN 55440-1441
Air Consumption
Size
(CFM)
1.2 mm
11*
1.8 mm
13.8*
1-800-742-7731, www.sharpe1.com
310584D, 4/2006
THE SPRAY GUN PEOPLE
FOR PRODUCT INFORMATION CALL:
1-800-742-7731
Recommended Usage
Pressure feed production
Medium solids, colors and clears
Advertisement
Table of Contents
Related Manuals for Sharpe 310584D
Summary of Contents for Sharpe 310584D
- Page 1 * At 50 psi (345 kPa, 3.4 bar) SHARPE MANUFACTURING COMPANY • P.O. BOX 1441, MINNEAPOLIS, MN 55440-1441 Air Consumption (CFM) Recommended Usage Pressure feed production 13.8* Medium solids, colors and clears 1-800-742-7731, www.sharpe1.com 310584D, 4/2006 THE SPRAY GUN PEOPLE FOR PRODUCT INFORMATION CALL: 1-800-742-7731...
- Page 2 This warranty is in lieu of all other warranties, expressed or implied, including warranties of merchantability and fitness for a particular purpose. Some states do not allow the exclusion or limitations of incidental or consequential damages, so the above limitations may not apply to you. WARNING 310584D...
-
Page 3: Operation
Fluid control knob (16) is factory set for maximum needle trigger travel and material flow. To decrease needle/trigger travel and decrease fluid flow, turn the knob clockwise. Adjust fluid pressure regulator until desired fluid flow rate is reached. CAUTION 310584D... -
Page 4: Cleaning And Maintenance
• Check for fluid leakage. Tighten fittings or replace equip- ment as needed. Gun Accessory Tools Part No. 41155: Packing Nut Removal Tool Part No. 41160: 1/2 in. Nozzle Removal Tool Lube . 2. Lube 310584D... -
Page 5: Troubleshooting
Hold gun about 6-8 inches (150-200 mm) from surface. Wetted Parts: stainless steel, carbon steel, aluminum, PTFE, low density polyethylene Weight: 1 lb. 3 oz. (0.54 kg) Spray Gun • 1/4 npsm (R1/4-19) air inlet • 3/8 npsm (R3/8-19) fluid inlet Solution 310584D... - Page 6 T1-TITANIUM NON-HVLP SPRAY GUNS Parts 310584D...
- Page 7 T1-TITANIUM NON-HVLP SPRAY GUN 310584D...
- Page 8 Air Filter Air Out Drain Leg Refrigerated Air In Air Dryer 6730 6950 8130 6930 6920 6910 6770 6760 6880 6885 6890 6895 1-800-742-7731, www.sharpe1.com 310584D, 4/2006 Dryaire Membrane or Desiccant Air Drying Systems at Paint Booth Ball Valve...