Checking Brake Fluid; Checking Power Steering Fluid - Toyota Sienna 2004 Operating Manual

Checking brake fluid

To check the fluid level, simply look at
the see- through reservoir. The level
should be between the "MAX"
"MIN" lines on the reservoir.
It is normal for the brake fluid level to go
down slightly as the brake pads wear. So
be sure to keep the reservoir filled.
If the reservoir needs frequent refilling, it
may indicate a serious mechanical prob-
lem.
446
04 SIENNA_U (L/O 0301)
If the level is low, add SAE J1703 or
FMVSS No.116 DOT 3 brake fluid to the
brake reservoir.
Remove and replace the reservoir cap by
hand. Fill the brake fluid to the dotted
line. This brings the fluid to the correct
level when you put the cap back on.
Use only newly opened brake fluid. Once
opened, brake fluid absorbs moisture from
the air, and excess moisture can cause a
dangerous loss of braking.
When the brake fluid must be replaced,
contact your Toyota dealer.
CAUTION
and
Take care when filling the reservoir
because brake fluid can harm your
eyes and damage painted surfaces. If
fluid gets in your eyes, flush your
eyes with clean water immediately. If
you still feel uncomfortable with your
eyes, go to the doctor.
NOTICE
If you spill some of the fluid, be sure
to wash it off with water to prevent
it from damaging the parts or paint.

Checking power steering fluid

If cold O.K.
If hot O.K.
Open
Close
If cold add If hot add
Check the fluid level through the reser-
voir. If necessary, add automatic trans-
mission fluid DEXRONJII or III.
If the vehicle has been driven around 80
km/h (50 mph) for 20 minutes (a little
more in frigid temperatures), the fluid is
hot (60FC—80FC or 140FF—175FF). You
may also check the level when the fluid
is cold (about room temperature,
10FC—30FC or 50FF—85FF) if the engine
has not been run for about five hours.
2004 SIENNA from Jan. '03 Prod. (OM45408U)