If Your Vehicle Will Not Start - Toyota Sienna 2004 Operating Manual

Hide thumbs Also See for Sienna 2004:
Table of Contents

Advertisement

If your vehicle will not start—

(a) Simple checks
Before making these checks, make sure
you have followed the correct starting pro-
cedure given in "How to start the engine"
on page 380 in Section 3 and that you
have sufficient fuel. If your vehicle is
equipped with the engine immobiliser sys-
tem, also check whether the other keys
will start the engine. If they work, your
key
may
be
broken.
Have
the
checked at your Toyota dealer. If none of
your keys work, the system is possibly
broken. Call
your Toyota dealer. (See
"Keys (with engine immobiliser system)"
on page 10 in Section 1- 2.)
If the engine is not turning over or is
turning over too slowly—
1. Check that the battery terminals are
tight and clean.
2. If the battery terminals are O.K., switch
on the interior light.
3. If the light is out, dim or goes out
when the starter is cranked, the battery
is discharged. You may try jump start-
ing. See "(c) Jump starting" on page
393 for further instructions.
If the light is O.K., but the engine still will
not start, it needs adjustment or repair.
Call a Toyota dealer or qualified repair
shop.
392
04 SIENNA_U (L/O 0301)
NOTICE
Do not pull- or push- start the ve-
hicle. It may damage the vehicle or
cause a collision when the engine
starts. Also the three- way catalytic
converter may overheat and become a
fire hazard.
key
If the engine turns over at its normal
speed but will not start—
1. Turn the ignition key to "ACC" or
"LOCK" and try starting the engine
again.
2. If the engine will not start, the engine
may be flooded because of repeated
cranking. See "(b) Starting a flooded
engine" on page 392 for further instruc-
tions.
3. If the engine still will not start, it needs
adjustment or repair. Call a Toyota
dealer or qualified repair shop.
(b) Starting a flooded engine
If the engine will not start, your engine
may be flooded because of repeated
cranking.
If this happens, turn the key to "START"
with the accelerator pedal held down.
Keep the key and accelerator pedal these
positions
for
15
seconds
and release
them. Then try starting the engine with
your foot off the accelerator pedal.
If the engine does not start after 15 se-
conds of cranking, release the key, wait
a few minutes and try again.
If the engine still will not start, it needs
adjustment or repair. Call a Toyota dealer
or qualified repair shop for assistance.
NOTICE
Do not crank for more than 30 se-
conds at a time. This may overheat
the starter and wiring systems.
2004 SIENNA from Jan. '03 Prod. (OM45408U)

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents