Toyota Avalon 2002 Operating Manual page 113

Hide thumbs Also See for Avalon 2002:
Table of Contents

Advertisement

The cruise information display indicates
the following information.
1. Instantaneous fuel consumption
2. Average fuel consumption
3. Average vehicle speed
4. Driving range
5. Driving time
Every time you push the "DISPLAY" but-
ton, the display toggles through this infor-
mation.
The displayed values in the cruise infor-
mation display
indicate general driving
conditions. Accuracy varies with driving
habits and road conditions.
If the electrical power source has been
disconnected, the display will automatically
be set to instantaneous fuel consumption.
To set the unit, push the "MODE" button
until the unit display appears and blinks.
Then push the "RESET/ADJ" button to se-
lect km/liter or mile/gallon. (At this time,
the outside temperature and air condition-
ing displays also change.)
After setting the unit, push the "MODE"
button until the display returns to normal
calendar mode.
'02 AVALON U (L/O 0107)
1. Instantaneous fuel consumption
("INST ECON")
The instantaneous fuel consumption is
calculated and displayed based on dis-
tance and fuel consumption for 2 sec-
onds with the engine running.
The displayed value is updated every 2
seconds.
Note that an accurate figure may not be
shown in the following cases.
D
When the vehicle is stopped with the
engine running, the display will indicate
the extremely high fuel consumption.
D
When the vehicle is driving down a
long slope, applying the engine brake,
the display will indicate the extremely
low fuel consumption.
The calculation is reset when the ignition
switch is turned off.
2002 MY AVALON_U (OM22493U)
2. Average fuel consumption
("AVG ECON")
Average fuel consumption is calculated
and displayed based on total driving
distance and
total
fuel
consumption
with the engine running.
The displayed value is updated every 10
seconds.
To
reset
the
calculations,
push
"RESET/ADJ" button.
The calculation is reset when the ignition
switch is turned off.
3. Average vehicle speed
("AVG SPEED")
Average vehicle speed is calculated and
displayed based on total driving dis-
tance and total driving time with the
engine running.
The displayed value is updated every 10
seconds.
To
reset
the
calculations,
push
"RESET/ADJ" button.
The calculation is reset when the ignition
switch is turned off.
the
the
113

Advertisement

Table of Contents
loading

Table of Contents